Before choosing belt size PLEASE read the belt sizing guide below. Do NOT just go by your pants size as it can lead to an incorrectly fitted belt. 

For an optimal fit, there should be 2″ to a max of 6″ of open space between your belt ends. For instance, if your measurement is 36”, you should go with a MD belt which will leave about 3” of open space. Keep in mind, if you prefer your bags to sit further back, order on the small side.  

 [Your size - belt pad length = between 2-6 inches]

Introducing the Carpenter Set, your ultimate all-around tool belt suitable for a wide range of trades. This versatile setup will be your reliable companion throughout various construction phases, from framing to finish work. The Carpenter Set includes a contoured belt with a robust metal COBRA® buckle, featuring the C1 bag on the dominant side and the S2 bag on the non-dominant side.

Tool Bag Configuration:

• Tape pouch
• 5 tool slots in the main pouch (three along the inside back and two inside the front)
• Single outside lower pouch with a tool slot
• Rear tool loop
• Pencil/utility combo up front with three small slots and one deep pocket
• Overall length is approximately 14".

Fastener Bag Configuration:

• 3 elastic nail set slots in the tape pouch
• Speed square slot
• Lower tool slot
• Side-by-side outside pouches
• Slots in each fastener pouch
• Reinforced bar slot on the underside of the bag
• Overall length is approximately 14".

As with all Badger bags, the main and fastener pouches' bottom sections are reinforced with tactical webbing made in the USA, providing enhanced resistance to punctures and abrasions. The Carpenter Set is here to make your work easier and more efficient.